1.3 Removing and installing the glove compartment
1.3.1 Glove compartment on front passenger side
Removing
– Remove infotainment control unit ⇒ Communication; Rep. gr. 91 ; Infotainment system; Removing and installing control unit for information electronics 1 - J794- .
– Remove screws -2- (1,5 Nm).
– Detach the glove compartment -1- from the dash panel.
– Detach intake hose for AC glove compartment.
– Detach the plug from the glove compartment light.
– Disconnect other plugs, if applicable (depending upon vehicle
equipment).
– Remove glove compartment from vehicle.
Ver el archivo adjunto 30978
1.4 Removing and installing the control unit for information electronics 1 - J794-
Removing
– Remove the data storage device that is still in the Infotainment control unit ⇒ Karoq Owner's Manual .
– Switch off the ignition and all electrical components.
– Remove glove compartment with frame on the front passenger side and rotate slightly downwards
– Separate the retaining clip of the wiring loom between the infotainment control unit and the dash panel cross member.
– Insert unlocking tools into the openings in the control unit
-see fig.- until there is an audible click.
Ver el archivo adjunto 30979
– Compress plug catch -arrows-.
Ver el archivo adjunto 30980
– Open catch clamp -arrow- and disconnect plug.
– Release and pull off other plug connections.
Installing
Installation is performed
Ver el archivo adjunto 30981